Microframe Corporation 3007 Series Guida Utente Scaricare il pdf (Pagina 232)

2-50

Messages

REBUILD-19: The utility could not access the output

directory specified. Directory_name might not exist or did

not allow write access.

Verify that the directory exists and that the person running the

rebuild utility has read/write permissions to the directory.

REBUILD-20: The utility is processing file_name

For a successful rebuild, the utility reports “The file was rebuilt

successfully.”

REBUILD-24: An error occurred accessing file_name.

Make sure you specified a valid file name.

Verify that the file name is correct and try the rebuild operation

again.

REBUILD-25: The utility is setting the owner name of an

empty target file

Verify that file being rebuilt and the target file are what you want.

REBUILD-26: The utility is dropping the indexes of an

empty target file

The rebuild process outputs the following information to provide a

status of its operation.

REBUILD is reading the first record from the old file.

REBUILD is inserting records into the new file.

REBUILD is reading records from the old file.

REBUILD is putting back indexes on the new file.

REBUILD-27: The utility could not create the temporary

file in the output directory during conversion

Verify the directory and that the person running the rebuild utility

has read/write permissions to the directory.

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 251 252

Nessun commento

Microframe Corporation 3007 Series Guida Utente Pagina 232